Hook up studio
Joe is a musician, engineer, and producer in NYC. And I assume you've checked the monitors with various commercial recordings as well as your own mixes.
Do you want to learn more about acoustics? Fig 1 Low-and High-Frequency adjustments on the rear panel of a studio monitor. Of course you'll want to check that no tone controls are boosting the low end unintentionally.
A couple of weeks ago, I bought a set of KRK Rokit 5 monitoring speakers since many review sites this was what made me decide on it http: Want to join the discussion? What all do I need to hook up studio monitors to a computer.
Thanks for your response. I don't understand the Fig.
1. Avoid the Hype
Avoid Poor Angles Positioning the monitors either too close together or too far apart can mess up your stereo panning decisions. Any "Loudness" buttons should be off -- those are intended to compensate for quiet listening levels by strongly boosting bass, but they're notorious dating phoenix overdoing it, and they should never be switched on for normal-level monitoring.
Fig 2 Free-standing placement L vs wall-placement R of hook up studio monitors.
So I chose to equalize the setup dBs at that crossover point. More articles by this author.
I'd say Hz is near the top of the range—I prefer around 80 Hz or so, but if the satellites are on the smaller side. Hosted by Nimbus Hosting.
Here are 6 suggestions—things to avoid—to get the best results. Two questions on point In this enlightening read, Joe Albano discusses 7 things which can be avoided. Need to get rid of an older machine, but